General Safety Notes - BITO WS-L Instrucciones De Montaje

1. Exclusion of liability / Safety instructions
1
The present instructions of assembly and use must be
made available to every user before a storage installa-
tion goes into operation.
All instructions given in this document must be follo-
wed at all times.
BITO-Lagertechnik disclaims liability for all damages
arising from non-observance of these instructions of
assembly and use.
BGR 234 Observe the
regulations
issued by
your national/
local Occupa-
tional Accident
Insurance
Institution(s).
General remark
Risk of slipping
and falling
Hand injuries
Do not climb on
shelving
Safety gloves
6
GB

2. General safety notes

BITO shelving and racking is intended for storing and picking
unit loads such as cartons, bins and containers or individual
items.
This storage installation has been designed for manual loa-
ding and retrieval (servicing with lift trucks is not allowed).
Unit loads, shelf loads and bay loads must not exceed rated
load capacity limits. Make sure that loads are evenly distri-
buted since structural design has been been calculated for
uniformly distributed loads.
Head
protection
Any other use or any use exceeding that specifi ed is an
infringement of use for the intended purpose.
Follow the instructions on design & layout, components &
Safety shoes
technical equipment, assembly & operation specifi ed in the
order documents.
Observe your national/local safety regulations for warehouse
Protective
equipment and machinery issued by your statutory accident
eyewear
insurance association(s) as well as the regulations set up by
your occupational health and safety at work acts and relevant
general accident prevention regulations.
High visibility
vest
The present instructions do not apply for shelving and
racking used outdoors or in harsh environments subject to
General remark
wind, snow and other mechanical stress factors. Moreover,
load capacities indicated in the present document are not
valid for earthquake hazard zones (structural design does not
resist seismic forces). Inform BITO in writing if your installa-
Hearing
protection
tion is to be set up in an earthquake hazard area and request
adaptation of structural design parameters to the seismic
requirements of your region.
Damaged or deformed racking components must immediate-
ly be replaced.
BITO Shelving and racking is not suited for use in environ-
ments with exposure to corrosion, splashing liquids, decom-
position, vibrations, explosions, radiation.
It is not permitted to use loads or load carriers which due to
their nature are subject to oxidation, rust, decomposition or
which might impair proper functioning of any kind of mecha-
nism.