Mark LX 166 Manual De Uso página 2

EN
1. Inspection
Thanks for your purchasing, please read this manual carefully before
general information for your safe
and better operation.Check the goods is receive in good condition,
refers to the following list:
1. LASER device x1
2. Notices
1. Perform the Instruction Manual for operation, please don't disassemble
be made by professional technician.
The laser light has a fault, please inquire with the professional or contact with the factory.
2. The light well protected against dampness, moisture, rust and shock. Do not use the product in dusty place.
3. The distance between lighting and the object that light falls on should be more than 1 meter.
4. Prevent other subject enter into the lighting.
5. Ensure the fan is not blocked.
6. Do not look into the laser source
7. Do not turn on and turn off frequently, and avoid to turn on the power for a long time.
8. Please power off the lighting for 15 minutes after running two hours,
cooling state.
9. Do not touch the laser lighting by wet hand and forcefully pull the power line.
10. Prevent the laser light from strong vibration or punch.
11. Do not dismantle the lighting.
12. Please directly contact with the local dealer when the trouble occurred.
13. When to be transported, use the original package to avoid shocking.
3. Installation
1. Firstly, be sure that the using voltage is match with the voltage marked on the light.
2. Installation should be made by professional technician. Fix the laser
light to you need.
3. Be sure that there is no flammable or explosive subject nearby.
keep more than 15cm between the wall and the laser light.
same time,
4. Please check whether the fan and the exhaust is blocked.
5. There is a hole for connection. When hang the laser light,
light weight.
6. It's essential to be earthed well for the sake of safety.
7. It's very important that connect the ground line to ground.
4. Warning
1. Power off before installation or maintenance.
2. The danger of this laser light is CLASS III B. It's dangerous for observing laser. The safe minimum distance
is 13cm; the safe maximum time is 10 seconds
3. Keep at least 0.5 meters distance between the lighting and flammable material
User Manual/Manual de Uso
LX 166
CAUTION
2. Instructions manual x1
CAUTION
Laser dangerous,
Do not open source;
High voltage risk,
Do not dismantle
operating the system. It gives you
and check for the contents in the package
3. Power cable x1
the light rudely. Installation should
ensure that the laser system is in well
lighting and adjust the angle of the
The least distance is 0.5 meters. At the
be sure the cable can undertake 10 times of the
!
Pag. 1