STARLINK Long Manual Del Usuario página 8

INSTALLATION
Instructions
Unplug your Starlink from the wall before beginning
the installation process.
NOTE: Prior to your permanent install, use the Lawn Mount in the
internet kit to perform an initial setup of the Starlink. Note the direction
and tilt of the Starlink and ensure your final install location will provide a
clear view for this orientation.
1. Plan your install. Use a stud finder to locate a stud
on an exterior wall. Ensure location will allow the
Starlink to fully rotate without hitting the roof.
2. Place mount template over stud making
sure holes are aligned vertically.
3. Drill pilot holes using the two holes on the template
as your guide.
4. Apply silicone sealant into the top hole. Use the drill
with the socket to drive in the top screw. Leave a
~1/2" (12.7 mm) gap for the mount to fit over.
Apply silicone sealant to bottom hole.
5. Place the Long Wall Mount over top screw and slide
it down to hook it onto screw.
ENGLISH