Bosch PAM20001 Manual De Instrucciones página 36

During air conditioning, the condensed water
produced evaporates automatically and is
expelled outdoors together with the expelled
air through the hot air expulsion tube.
In conditions of extreme humidity, the
appliance accumulates condensed water in
the appliance's rear tank. When a certain level
is reached, the removable tank full symbol
appears on the screen to indicate that the tank
needs to be emptied. The appliance stops
working when this happens. To empty the
removable tank, press the handle and remove
the tank carefully. Empty the water down the
nearest drain.
The symbol disappears from the screen when
the water tank has been emptied and replaced
on the appliance properly.
Warning!
When you turn the appliance back on again
after emptying all of the water, do not
forget to replace the removable tank on the
appliance properly. Should you fail to do
so, the symbol will not disappear from the
screen and the appliance will not work.
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before the
compressor starts up again. This period of
time is required in order to ensure correct
appliance operation.
Dehumidification
In this operation function, the appliance
reduces the humidity in the atmosphere. The
appliance purifies the air in the room at the
same time in order to create a pleasant
atmosphere.
❏ Plug the appliance into the mains electricity
supply.
❏ Fit the hot air expulsion tube outside as
indicated in "Preparing the appliance before
use".
❏ Lift the air director on the top of the
appliance.
There are two ways of expelling condensed
water: via the removable tank and in
continuous mode.
Instructions for Use
Dehumidification via the removable tank:
• Check that the removable tank is fitted onto
the appliance properly and that the plug is
fitted onto the water drainage pipe to prevent
water from leaking onto the support surface.
• The water level in the removable tank rises.
When it reaches its maximum level, the
symbol
symbol also appears when the removable
tank is not properly fitted into its housing.
• In both events, it is necessary to extract the
tank and pour the water carefully down the
nearest drain.
Dehumidification in continuous mode:
• Place a receptacle at the end of the water
drainage pipe to collect the condensed
water or lead the pipe to the nearest drain.
• Remove the plug from the water drainage
pipe on the back at the bottom of the unit.
When operating in this mode, the appliance
does not stop or warn that the external
receptacle is full via the symbol
• Select the dehumidification function
"Selecting the operation function").
• Select the operation speed, (see "Selecting
the speed").
Warnings
The amount of water dehumidified from the
atmosphere may reach 38 litres in 24 hours
depending on atmospheric conditions.
When the appliance is operating in the
dehumidification function, the temperature
does not appear on the screen and cannot
be selected or modified.
Warning!
Do not forget to replace the plug onto the
water drainage pipe when you change
function, otherwise the appliance will shed
water when operated.
Remember that ambient temperature must
be 18°C or higher in order for the appliance
to work.
The appliance expels hot air through the
drainage pipe when operating in
dehumidification function. This is
necessary for the appliance to work more
efficiently in this operation function.
36
appears on the screen. This
.
(see