Publicidad
Idiomas disponibles
Idiomas disponibles
EN
HOW TO INSTALL THE OXIBRAKE?
The OxiBrake brake sensor fits most handlebars by slipping the silicone sleeve over the brake lever (see figure 1 page
2). It adapts to the shape of the lever by bending between 0 and 45° (see figure 2 on page 2).
WARNING! Do not bend the OxiBrake repeatedly.
FIRST USE.
Before using the OxiBrake for the first time, fully charge the battery using a micro USB cable connected to a 5V USB
charger (see figure 3 on page 3). A flashing red light indicates that the OxiBrake is charging. The flashing light turns
red&green at 50% capacity. When the light turns off, the battery is fully charged.
FUNCTIONNING.
The OxiBrake is automatically switched on when you press the sensor area (see figure 1 on page 2) while operating
the brake lever. The indicator light then lights up red when the light is activated as a brake light.
If the OxiBrake does not light up, be sure to turn on the light and press the OxiBrake button once to check the battery
level (see figure 1 on page 2).
To check the battery level while using, press the button (see figure 1 page 2). The light is green when the battery is
sufficiently charged and is red when the level is low. The OxiBrake will also flash red 3 times when it is no longer in use
if the battery level is low.
PRECAUTIONS FOR USE.
WARNING! Do not immerse the device in water and do not dismantle the device, as this will invalidate the warranty.
Do not dispose of the battery in fire (risk of explosion).
WARNING! This product and batteries it contains cannot be disposed of with household waste. They are subject to
selective sorting and must be deposited in an authorised collection area for recycling.
WARRANTY.
We apply the legal warranty periods on all our products. For more information on terms and conditions, please
contact your local dealer or visit our website at www.overade.com
125 mm
Publicidad
