Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1. INTENDED USE
- This tool is intended for drilling in concrete, brick, wood and stone (specific accessories should be
used).
- The hammering system in this tool outperforms any traditional ratcheting drill when drilling in
concrete.
- This tool is designed for use in combination with all standard SDS + accessories.
2. PRODUCT ELEMENTS
1) On/Off switch
2) Switch for changing direction of rotation
3) Switch for selecting operating mode
4) Locking sleeve
3. SAFETY
Warning! Read all instructions. Failure to follow all instructions listed below may result in electric
shock, fire and/or serious injury.
- Ensure the switch is in the off position before inserting battery pack. Inserting the battery into
power tools that have the switch invite to accidents.
- Recharge only with the charger specified by the manufacturer. A charger that is suitable for one
type of battery pack may create a risk of fire when used with another battery pack.
- Use power tools only with specifically designated battery packs. Use of any other battery packs
may create a risk of injury and fire.
- Avoid damage that can be caused by screws, nails and other elements in your work piece; remove
them before you start working.
- Always check that the supply voltage is the same as the voltage indicated on the nameplate of the
charger (chargers with a rating of 230 V or 240 V can also be connected to a 220 V supply).
- In case of electrical or mechanical malfunction, immediately switch off the tool or unplug charger
from power source.
- Use only accessories with an allowable speed matching at least the highest no load speed of the
tool.
- People under the age of 16 years should not use this tool.
- Be careful not to drill or drive into areas where electrical wires may be contacted.
- Ensure that the switch (2) is in the middle (locking) position before making any adjustments or
changing accessories as well as when carrying or storing the tool.
-Do not touch the contacts in the charger.
-Do not expose the tool to rain. Never charge the battery outdoors.
-Do not expose battery to fire.
- When damaged, and under extreme usage and temperature conditions, batteries may start to
leak.
- If liquid comes into contact with the skin, wash quickly with soap and water, then with lemon juice
or vinegar.
- If liquid gets into the eyes, flush eyes with clean water for a minimum of 10 minutes and seek
immediately for medical attention.
- When battery is not in tool or charger, it should be kept away from metal objects such as nails,
screws, keys, etc. to prevent short-circuit.
- Do not use charger when damaged. Take it to an official service center.
- Do not use battery when damaged. Replace it immediately.
- Do not disassemble charger or battery.
2
Publicidad
