JFA Electronicos REDLINE J4 Manual De Instrucciones página 18

J4 REDLINE AUDIO PROCESSOR - INSTRUCTION MANUAL
CONNECTING DIAGRAM
Connect the power cables according to the diagram below.
Check out the example of how the outputs can be congured, remembering that the outputs can
be congured in other ways.
Connect to the
seasoned main
RCA player
Output 1
Entry level
adjustment
IMPORTANT RECOMMENDATIONS:
The recommended wiring gauge is 1.5mm² for the positive-negative wires and 0.50mm² for the
remote wires. The J4 REDLINE Processor should be xed on a stable and easily accessible base
(support) away from heat sources. It is not recommended to install the product on the sides of
loudspeakers, due to vibration. Do not x directly on the Vehicle Housing.
Never power the J4 REDLINE Processor from the original vehicle wiring. To avoid noise pickup, use
shielded signal cables. They must not pass together to the power lines and must be as short as
possible. Observe the cable crossing points. Sharp edges of Ataria or living corners can cut them,
causing future problems.
The J4 REDLINE Processor must be connected before the ampliers. If this procedure is not
followed, damage to the speakers may occur. For the purpose of safe activation of the ampliers
the J4 REDLINE Processor has a REMOTE OUT output, which sends the +12V signal seconds after
the crossover is triggered.
IMPORTANT: Any connection in the power, input or output connectors
must be made only with the device switched off.
Connect to
output remote
player
Output 2
Amplier Amplier
1
Connect to
remote input
two ampliers
Output 3
Amplier
2 3
Output 4
Amplier
4
1 2