Scheppach SprayVac20 Traduccion Del Manual De Instrucciones Originale página 28

16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not run
Low or lacking suction
capacity
Float does not switch
off the device
Dust or dirt is blown out
of the device
Water channel leaking
Low or no spraying
performance
Only air coming out of
the spray nozzle
28 | GB
Possible cause
Check whether the plug is plugged
in.
Check whether there is power to the
socket.
Check whether the vacuum cleaner
on/off switch is switched on
On/off switch defective
Carbon brushes worn
Engine defective
Air regulation on the handle open
Vacuum hose or nozzles clogged
Container open
Container or dust bag full
Filter full or clogged
Float in filter cage does not move
Float in filter cage does not move
Filter absent or not fitted correctly
Water channels not connected
properly
Sealing ring missing or porous
Water channel clogged
Water channel kinked
Spray pump defective
Water tank empty
Water channel is not connected to
the water tank
www.scheppach.com
Remedy
Plug the mains plug back in to the socket.
Check socket, mains connection cable, lead,
plug and fuse, if necessary, have repaired by an
electrician
Switch the on/off switch on.
Repair by customer service department
Close air regulation
Switch off the hoover to clear blockages and
obstructions.
Close container
Empty container / replace dust bag
Empty, clean or replace filter
Clear the float
Clear the float
Insert absent filter or check correct fit of filter
Connect and lock the water channels correctly
Insert / replace sealing ring
Clean water channel
Avoid kinking the water channel
Repair by customer service department
Fill up the water tank
Fit the water channel correctly