ledscom LC-L-253 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Remove the mounting plate (1) by
loosening the screws (2). Then carefully
lay the light on its side so that it cannot be
damaged.
3. Drill holes in the mounting base and
insert two dowels there. The positioning of
the holes should correspond to those of the
screw holes (3) on the mounting plate.
Make sure that the dowels are flush with
the substrate.
4. Then fix the mounting plate (1) to the
mounting base with the aid of two screws.
5. Connect the wires of the cable according
to "Figure 2".
6. Place the light back on the mounting
plate (1). Then retighten the screws (2) to
fix the light to the mounting plate. The
installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Mounting plate
2: Screws
Figure 2
Wall lamp (LC-L-253) - Assembly instructions
3: Screw holes
10/2022