Descargar Imprimir esta página

Crosley Coda CR7017B Manual De Instrucciones página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Tonearm Counterweight Adjustment for Stylus Pressure
1. Remove the stylus protector from the cartridge and avoid touching the stylus
tip during the adjustment.
2. Release the tonearm Hold Down Clip, gently hold the tonearm and move it
away from the Tonearm Rest. At this point, the tone arm is unbalanced and
free to swing.
3. While gently holding the tonearm, carefully rotate the Counterweight towards
the front of the turntable until the tonearm is horizontally balanced and hovers
freely just above the platter without the stylus touching the platter surface.
4. Return the tonearm to the Tonearm Rest and lock the Hold Down Clip.
5. While holding the counterweight steady without any rotation, rotate carefully
only the Downforce Scale Dial until the "0" on the scale lines up with the
centerline marked along the top of the tonearm.
6. Rotate the counterweight including the downforce scale dial counter-
clockwise (as seen from the front of the turntable) until the scale shows the
recommended pressure value for stylus.
Note: The recommended pressure for the factory-installed cartridge is 3.5g. The
cartridge only goes up to 2g. You will need to make one full rotation and set it to 1.5g to
reach 3.5g.
Clock Setup
Manually setting the clock can only be done in STANDBY mode.
1. In STANDBY mode, long press the Tuning knob.
2. Rotate the Tuning knob to adjust between the 12 or 24 setting. Press Tuning
knob to confirm.
3. Rotate the Tuning knob to change the hour digits to the correct hour. Press
the Tuning knob to confirm.
4. Rotate the Tuning knob to change the minute digits to the correct minute.
Press the Tuning knob to confirm
Stereo System Connection
When used as a line output, the jacks output analog line-level signals and could
be connected directly with a pair of active speakers or the appropriate input of
your stereo system.
Aux Input Connection
You can connect an audio device to this unit and play your music through its
speakers. To do this, press the Aux button, connect the 3.5 mm auxiliary cable
between your audio device, and the Aux In Jack of this unit and start playing the
music.
6

Publicidad

loading