RAWLINK 36992 Manual De Instrucciones página 11

BICYCLE LIGHT WITH POWERBANK FUNCTION
Introduction
To get the most out of your new bicycle
light with powerbank function, please read
through these instructions before use. Please
also save the instructions in case you need to
refer to them at a later date.
Technical data
Built-in battery:
Voltage/current input and output:
Light intensity: 5 settings, max. 1,000 lm
Flash function:
Burn time:
Range:
Display with battery indicator
Installation
Feed the strap through the bracket and
attach the bicycle light around the handlebar
of the bicycle. Tilt the bicycle light to the
required angle.
See fi gure 1 at the front of these instructions.
Use
Press and hold the 1 or 2 button for approx.
1.5 seconds to switch the bicycle light on and
off . See fi gure 2.
Press button 1 or 2 to increase or decrease
the brightness or to change the function in
this order:
100% – 65% – 40% – 15% – 2% – strong fl ash
– weak fl ash – day fl ash – off .
3.7 V 4,800 mAh
5 V 1 A
3 settings
min. 5 hours at lowest
light intensity
up to 400 m
If you press one of the buttons while the
bicycle light is on, the remaining battery
capacity and operating time will be shown
on the display.
Note! If the temperature of the bicycle light
gets too high, it will automatically switch to
40% brightness. Once the bicycle light has
cooled down suffi ciently, it can again be used
at 100% brightness.
Use as a powerbank
Connect your mobile phone to the USB
socket under the cover on the rear of the
bicycle light using a suitable charging cable
to charge your mobile phone. See fi gure 3.
Charging the bicycle light
Connect the charging cable provided to the
USB socket under the cover on the rear of the
bicycle light.
Connect the charging cable to a USB charger,
a USB port on a computer or another USB
power supply. See fi gure 3.
The white line on the display will fl ash during
charging and turn off once the battery is fully
charged. A full charge takes up to 10 hours.
Charge the bicycle light and store it in a dry,
cool and dust-free location if you do not
intend to use it for a prolonged period.
Charge the bicycle light at least once every
three months, regardless of whether or not it
has been used.
GB
11