Sebson AC OUT TIMER D1 Manual Del Usuario página 8

▪
To set the summer or winter time for the current time, press both buttons "CLOCK" and "ON/AUTO/OFF"
simultaneously.
▪ The summer time is shown on the display with "S". In this case the time is presented by an hour.
Delete saved times:
To clear a stored time, press the "TIMER" button until the desired time is displayed. Then press the "RST / RCL"
button.
Note:
Please always delete both times (ON and OFF).
Set of time:
▪
To program a period during which the unit should turn on and off, briefly press the "TIMER" button.
▪ To select the desired day of the week, press the "WEEK" button.
▪
Use the "HOUR" and "MINUTE" buttons to set the desired start time (ON).
▪ To set the time in which the timer is to be switched off (OFF), press the "TIMER" button again. Set the day
and time using the "WEEK", "HOUR" and "MINUTE" buttons as described in the last two steps.
Important:
Please make sure that you always select a day of the week when entering the two times!
▪ To program more time, briefly press the "TIMER" button and repeat the last three steps.
▪
A total of 10 different periods can be programmed. Important: Please ensure that the set periods do not
overlap! This prevents the timer from turning on unplanned.
▪
When you have finished setting the respective time periods, press the "CLOCK" button to display the
current time and the current day of the week in the display.
▪
To activate, press the ON/AUTO/OFF button until "AUTO" appears on the display.
Manual deactivation or activation of a connected device:
With the "ON/AUTO/OFF" button, the device connected to the timer can be directly switched on (ON) and switched
off (OFF) as well as the stored programs (AUTO). Pressing this button several times will toggle between the 3
modes displayed on the display as "AUTO", "ON" and "OFF".
"AUTO" mode, the previously set switching state will not change until one of the stored programs is activated.
Deactivation or activation the random mode:
With the random function, the switching operations can be delayed according to the random principle. These
delays are between 10 and 31 minutes between 6 PM till 6 AM. To enable or disable the random function, press
the "RANDOM" button. When the function is activated, a letter "R" is displayed on the display of the timer.
Reset device:
By pressing the "MASTERCLEAR" button with a pointed object, all previous settings can be deleted. Please press
the "MASTERCLEAR" button if the display shows errors or the buttons are no longer working properly.
Technical Data:
Operating voltage:
Maximum load:
Accumulator (chemical composition):
Electrical protection:
Protection class:
Information on the safe removal of the batteries or accumulators:
Warning:
Make sure that the battery or accumulator is completely empty.
Note:
If you switch from "ON" or "OFF" mode to
230V AC 50Hz
Max. 3.600W/ 16 (2)A
NiMH 1,2V >100h
IP44
III
8