Uline H-9881 Manual De Instalación página 2

Figure 3
Figure 4
Figure 5
PAGE 2 OF 9
INSTRUCTIONS FOR UNIT ASSEMBLY
1. Start with the lowest shelf. Snap the interlocking
pieces of shelf support (wide end down) around
the post at the lowest groove where shelf is to be
located. Slide the support up or down until it snaps
onto the groove. Add shelf support to the same
place on the remaining posts. (See Figure 3)
NOTE: NSF requires food service applications to
keep the lowest shelf at least 6" above the floor.
2. Slide post through underside of shelf until shelf slides
firmly over supports. (See Figure 4)
3. Stand unit upright. Gently tap shelf down to secure it.
(See Figure 5)
NOTE: Shelves will not be evenly spread
apart. Use discretion while spacing the rest
of the shelves. Spacing recommendations
are provided below depending on the model
number purchased:
0122 IH-9881