Lionelo Flower Manual De Usuario página 6

• Do not use the changing unit when any part is broken, torn or missing.
• Be aware of the risk of open fires and other sources of strong heat, such as
electric bar fires, gas fires etc. in the near vicinity of the changing unit.
Assembly instruction
1.
Take the travel baby bed out of the bag and loosen the adhesive straps.
Place the bed on the floor and put the bag aside (see fig. 1).
2.
Separate the legs pulling them apart. Keep the central lock up. Otherwise
handrails will not fit in the right place (see fig. 2).
Note! So that the sides of the cot / handrails are properly blocked, the central
blockade of the floor must be raised upwards. The baby rails will not lock when
the floor is unfolded.
3.
Pull the middle part of each top rail covered with material so that they fit
into place. Start with the longer rails, and then the shorter ones (see fig. 3).
4.
Push the middle lock until the surface is completely flat (you will hear the
click sound) (see fig. 4).
Base installation
Mount the platform with the zipper (fig. 5). Secure the zipper by fastening the
clasp (see figure 5a). Connect the stiffening pipes located at the bottom of the
platform together (Fig. 6). Place the mattress on a platform and connect it to the
platform with Velcro.
Changing table assembly instruction
Push the button marked on fig. 7 and connect short and long stiffening tubes of
the changing table. Install the plastic fastening elements on the long and short
sides of the bed.
Organizer installation
Put the hooks on the organizer and mount it on the bed frame.
Baby bed folding instruction
1.
Remove all the bed accessories. Remove the mattress, canopy, organizer
and all the other accessories. Grasp the centre handle located in the middle
of the floor and pull it up.
2.
To unlock the upper rails, press the indicated buttons on each side of them.
Pull it slightly up and then push it down. Unlock the shorter sides first, and
then do the same with the longer ones.
EN ‑ 6 ‑