Publicidad
Usage
Charging
1. Connect the battery station to a power outlet using the AC power adaptor cable.
2. Press the power button once to power on the battery station.
3. To charge the DJI RC Plus remote controller, connect the USB-C ports of the battery station and
remote controller using a USB-C to USB-C cable.
4. For TB30 batteries, make sure the charging mode is set to the mode required. The charging time
is shown in the diagram.
Storage Mode: Each battery pair is charged to 50% in sequence and kept at 50%
after charging. *
Ready-to-Fly Mode: Each battery pair is charged to 90% in sequence and kept at
90% after charging. *
Standard Mode: Each battery pair is charged to 100% in sequence.
* The battery station should be powered on to maintain the battery level in Storage Mode and Ready-to-Fly
Mode. Power off the battery station after charging, except for special situations such as fire emergencies.
Maintaining high power level in Ready-to-Fly Mode will affect battery life.
Battery Level: 20%
5. Insert the batteries into the battery ports to start charging.
A. For WB37 batteries, the battery station will charge the battery with the most power first.
B. For TB30 batteries, their charging sequence is illustrated below.
a. Between paired and singular batteries, paired batteries will be charged first. (Figure a)
b. Where there are multiple battery pairs (each formed by a top and bottom battery in the
sequence of A, B, C and D), the pair with the highest power will be charged first. (Figure b)
c. If none of the batteries are paired, the two batteries with the highest power will be charged
first. (Figure c)
4
2022 DJI All Rights Reserved.
©
Standard Mode
Ready-to-Fly Mode
30 min
12 min
90%
100%
Publicidad
