COOLZY-GO PC9B Manual Del Usuario página 3

GETTING STARTED
IMPORTANT
Always keep Coolzy upright. It may have been
stored or transported on it's side or laid flat by
mistake, so please stand it upright for at least 12
hours before plugging it into power and turning it
on. Failing to do so may damage the unit.
1) After removing Coolzy from the box, place it in
an upright position.
2) Remove the cable from the drawer at the back
of the unit and insert the plug into a wall outlet.
Make sure you push the drawer fully back in so it
is flush with the back panel.
3) Open the warm air deflector fully. This will
turn on the unit and the compressor will start.
4) Open the cold air deflector and allow 2 min-
utes for the air coming out to feel cold.
5) Keep a door or window open so fresh air circu-
lates unless it is extremely hot or windy outside.
6) Avoid using a fan nearby as it can disrupt
Coolzy's gentle air flow.
7) An adjustable nozzle (Focus Enhancer) is avail-
able for purchase as an accessory. It extends the
range of cooling and, after fitting the transparent
flap that comes with it, enables a higher angle of
air flow.
COOLZY-GO Model PC9B User Guide ENUS2022 Rev1.1
Drape a curtain as shown to exclude
light when sleeping. Make sure that
the room air intake is at least 6 in (15
cm) from the wall!
For a small room, place the unit near
an open window or doorway.
Position Coolzy close enough
for comfort. The ideal range of
distance is 5 - 10 feet (1.5 - 3
metres). Arrange the angle of the
cold air deflector so cool air flows
around face and shoulders.
For sleeping, arrange your unit
about 6 inches (15cm) from the
end of the bed. Adjust the cold
air deflector to the desired angle
so the cool air flows over your
face and upper body. It also works
with larger beds for two people.
3