Creative ROCK PILLAR SOLAR PATH LIGHT Manual De Instrucciones página 5

Maintenance
1
Battery replacement
NOTE: Use one AA size, 600mAh, 1.2V Nickel Metal Hydride
rechargeable battery. For best performance, replace with a Nickel
Metal Hydride rechargeable battery annually.
IMPORTANT: Dispose of the battery in accordance with local,
state, and federal regulations.
IMPORTANT: When storing any solar product for an extended
period of time, remove the batteries. Storing any solar product
without regular recharge or removal of batteries could cause
permanent damage to the rechargeable batteries.
□
Rotate counterclockwise and remove the top cap (A) from the lens (B).
□
Unscrew the bottom plate (F) from the top cap (A) and remove it.
□
Remove the old battery (E). Replace with a new AA size, 1.2V Nickel
Metal Hydride rechargeable battery – The recommended replacement
battery capacity should be 600~800mAh.
□
Replace the bottom plate (F) with the four screws, and then replace the
top cap (A) to the lens (B).
Care and Cleaning
Periodic cleaning of the solar panel and glass housing is quick and easy:
□
The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
□
Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Troubleshooting
Problem
The nightly run time is
shorter.
The solar light does not
turn on at night.
Possible Cause
The battery is not fully charged.
The battery is reaching the end of its useful life.
Your solar light is equipped with an AUTO/OFF switch
on the back of the solar box. This switch must be set to
AUTO prior to use.
The solar light is installed close to other light sources,
which may keep the solar light from turning on at night
automatically.
Solution
Ensure the solar light is located in an area where it can
receive the maximum amount of full, direct sunlight every
day. Keeping the solar panel clean is equally important to
ensure the maximum charging performance.
Replace the old battery with a Nickel Metal Hydride (Ni-
MH) rechargeable battery.
Prior to use, check that the unit has been set to the AUTO
position and allowed to charge a full sunny day.
Relocate the fixture or eliminate other light sources.
5