Installation; Operation - Vortice VORT FOHN Serie Manual De Instrucciones

770 - Vort Fohn:Layout 1
ENGLISH

Installation

(Fig. 1,2).
N.B. The appliance must be installed by a
professionally qualified technician.
This dryer must be installed out of reach of persons
using the bath, the shower, or the washbasin, and in
accordance with all laws and standards governing
installation in the country where the appliance is
being installed.
The appliance should not be installed lower than 150
cm off the ground.
Installing the wall mount
- The wall mount can be installed in two different
ways: directly over a junction box (type A mounting),
or in the vicinity of one (type B mounting)
Type A mounting
- Break the cable grommet tab on the back of the wall
mount.
- Pull the wires coming out of the wall through this
hole.
- Secure the mount to the wall with provided rawl
plugs.
- Connect the cord to the terminal block (fig. 1).
Extract and refit the terminal block.
- Fit the front of the wall mount and screw it down
(screw included).
Type B mounting
- Break the cable grommet tab on the bottom of the
wall mount to fit the second cable grommet.
- Secure the mount to the wall with provided rawl
plugs.
- Pull the cable grommet over the mobile cord.
- Connect the cord to the terminal block (fig. 2).
Extract and refit the terminal block.
- Fit the cable grommet and secure the cord with the
retainer.
- Fit the front of the wall mount and screw it down
(screw included).
01/07/2010 9.05 Pagina 10

Operation

(Fig. 3,4,5).
Switch the appliance on by setting the wall mount
switch to "I": (fig. 3a: 1, 3b: 1); you can now use the
appliance and, if using the Plus version with razor
socket, the socket is now available for use (fig.3b: 2).
The razor socket delivers a maximum power of 20 W.
Using appliances which draw more current than this
trips the circuit breaker. You will than have to wait for
the breaker to reset before you can use the appliance.
On models with razor socket, the wall mount has a
two-position switch, 120V /60 Hz and 240V /50 Hz, to
set the mains voltage (fig. 3b: 3).
Operation of model 1200:
The appliance's handle has the following controls:
- power
- ON/OFF button (fig. 4: 2): hold this button down to
Operation of model 1600:
The appliance's handle has the following controls:
- power switch (fig. 5: 1): three positions:
- ON/OFF button (fig. 5: 2): hold down the button to
- speed switch (fig. 5: 3): three positions:
N.B. when the motor is off (speed switch set to 0), the
heating element will not turn on.
The appliance has the following modes:
Speed I:
Power I: absorption 750 W
Power II: absorption 1050 W
Power III: absorption 1300 W
Speed II:
Power I: absorption 1000 W
Power II: absorption 1250 W
Power III: absorption 1550 W
(Nero/Black pellicola)
switch (fig. 4:
600 W and 1200 W.
switch the appliance on.
I: max 1000 W
II: max 1250 W
III: max 1550 W;
operate the appliance.
0: motor off;
I: low speed;
II: high speed.
1): two positions: