Descargar Imprimir esta página

Samsung NX60 875 Serie Manual Del Usuario página 112

Ocultar thumbs Ver también para NX60 875 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
1. Make sure the oven door is closed completely and unlocked.
2. Tap
, and select Self Clean using the dial knob. Then, select the cleaning time
by turning the dial knob one or more times in accordance with the table below.
Left turn
2-hour cycle
3. Tap START. The oven door is locked and the oven begins to heat up.
4. When the self-cleaning cycle is complete, the oven beeps. The door will remain
locked until the oven temperature falls below 400 °F (200 °C). You can open the
door when it is safe to open.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
50 English
NX60T8755SS_AP_DG68-01322A-01_MES+EN.indb 50
NX60T8755SS_AP_DG68-01322A-01_MES+EN.indb 50
Default
Right turn
3-hour cycle
5-hour cycle
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
To delay starting a self-cleaning cycle
1. Repeat steps 1 and 2 on the previous page.
2. Select Set Delay Start.
3. Set the time you want the oven to start self-cleaning using the dial knob.
4. Tap START. The oven will start self-cleaning at your specified time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, tap OFF. The cycle turns off, but the door
remains locked and the Lock icon blinks until the oven temperature falls below 400 °F
(200 °C).
After self-cleaning
• The door stays locked until the internal oven temperature falls below 400 °F.
• When the oven has cooled down, wipe the oven surfaces with a cloth to remove ash residue.
• Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
• If you are not satisfied with the cleaning results, repeat the cycle. Wait until the oven
cools down and then start a new cycle.
• The cooling fan automatically runs for certain amount of time after self-cleaning.
• Self-cleaning does not operate within 2 hours after running the self-cleaning cycle.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air and/or
steam could burn you.
2021-02-19 오후 6:10:56
2021-02-19 오후 6:10:56

Publicidad

loading