2.3
Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
3
Description
3.1
Overview of the product
3.2
Intended use
The product described is a battery charger for Hilti Li-ion batteries with a rated voltage of 7.2 to 36 volts. It
is designed to be connected to power outlets providing an AC voltage (alternating current) of 100 to 127 V
(depending on country-specific version).
A list of the batteries approved for use with this product can be found at the end of this document.
3.3
Information displayed
3.3.1
Information displayed by the charger and battery
The supply voltage LED lights when the charger is plugged in and ready for operation.
Battery charge state
LEDs
Off
LEDs 1 to 4 blink first and
then light to indicate the
battery's state of charge.
Off
4
English
1
@
;
=
%
&
(
)
Charge status LED
Battery temperature
LED
Off
Off
Off
Off
Blinks
Off
Lights
Off
Release button with additional function
(state-of-charge display activation)
Battery
Battery state-of-charge LEDs
Supply voltage LED
State-of-charge LED
Battery temperature LED
Battery interface 1
Description
No battery is inserted.
Battery is inserted and
ready to charge.
The battery is charging.
The battery is fully charged.
2114856
*2114856*