Publicidad
Idiomas disponibles
Idiomas disponibles
WaveLinx Pro
Relay Switchpack Installation
1.
Ensure power is OFF to all circuits you will be working with.
2.
Secure the Wireless Universal Voltage Dimming
Switchpack to the Junction Box.
3.
Make all power connections:
a. The input black wire (HOT) of the Relay Switchpack
has HOT Switched output (red wire) to connect to
the load that will be powered through the Relay
Switchpack.
b. The input white wire (Neutral) of the Relay
Switchpack is also connected to the load directly.
4.
Make all low voltage connections:
a. The Relay Switchpack also includes a 0-10V output
to allow control of a single 0-10V control device.
b. The positive (dim) lead of the luminaires are
connected to the purple wire.
c. The negative (return) lead is connected to the
Pink terminal.
d. Use 20 – 24 AWG solid or stranded copper.
5.
Check all electrical and mechanical connections.
6.
Close up the Junction Box.
7.
Apply power to the circuit.
NOTICE: All new wiring must be fully verified before applying
power.
NOTICE: Designed for indoor installation and use only.
Dry location rated.
Wiring Diagram
WSP
Black
(HOT)
White
120-347
VAC
(Neutral)
Out-of-the-box Functionality
• Upon power up, the Relay Switchpack will be ON (closed)
until paired with Wireless Area Controller (WAC). Output of
0-10V set to 75% light output.
• Commissioning button will toggle Relay state when button is
pressed and released in less than 4 seconds.
• LED will indicate Relay state; if Relay is closed then the LED
is ON.
• When the Commissioning button is pressed for more than
4 seconds, the Relay Switchpack will search for a WaveLinx
Pro wireless network. The LED will blink at 0.5Hz (slow blink)
50% duty cycle while searching.
IB503102ML page 4
February 2022
Pink (Dimming)
Driver
Purple (Dimming)
Red (HOT_Switched)
Load
Wireless Universal Voltage Dimming Switchpack
Wireless setup
1.
Upon power up, the Wireless Universal Voltage Dimming
Switchpack will look for a WaveLinx Pro wireless network.
2.
When the Relay Switchpack joins a WaveLinx Pro wireless
network, the Relay turns OFF for 5 minutes.
• This allows for a visual inspection of which fixtures
received the join beacon from the WAC.
• Document which fixtures did not turn OFF - those fixtures
will stayhose fixtures will stay at 75% or full bright light
level.
3.
When connected to the WaveLinx Pro wireless network the
Relay Switchpack returns to full ON light level.
4.
When the pairing and 5 minute hold OFF is complete all
relays are part of the default area and the dimmable zone.
N
ote:
Please refer to WaveLinx Pro Mobile App manual to
complete configuration.
LED's Definitions
There are two major LED patterns for the Relay Switchpack:
• When the commissioning button is pressed for more
than 4 seconds, the LED blinks at 0.5Hz
(Slow Blink) 50% duty cycle for 10 seconds;
indicating that the Wallstation is searching for a
WaveLinx Pro wireless network..
• When the commissioning button is pressed for
less than 4 seconds, the Relay State will toggle
and the LED will indicate its state.
• LED ON = Relay Close.
• LED OFF = Relay Open.
• At any given time the Relay state can be
identified via the LED.
• LED ON = Relay Close.
• LED OFF = Relay Open.
www.cooperlighting.com
Publicidad
