Publicidad
Idiomas disponibles
Idiomas disponibles
EN
MOUNTING OPERATION
MK 51 / MK 52
The built-in stand adapter features a dynamic locking system that allows to adjust the
microphone position, resisting when struck or bumped. To mount the MK 51 & MK 52
on a stand and adjust its position, proceed as follows:
1. If it is necessary, screw the stand adapter onto the end of a microphone stand (see
figure 1). Adjust the stand height and position as necessary.
2. Pivot the MK 51 /MK 52 until it is in desired position relative to the drum head or
loudspeaker.
3. Lock the microphone in place rotating the adjustment knob on the stand. DO NOT
over tighten the knob with tools.
4. Connect an audio cable to the built-in XLR connector.
MK 51
Audio cable
MK 53
To mount the MK 53 on a stand and adjust its position, proceed as follows:
1. Use the screw to joint the integral stand mount with the clip (see figure 2).
2. Pivot the clip until it is the desired position relative to the drum head or loudspeaker.
3. Lock the clip in place rotating the screw until tight. DO NOT over tighten the knob
with tools.
4. Place the MK 53 into the clip
5. Connect an audio cable to the built-in XLR connector.
stand
figure 1
figure 2
3
MK 52
Audio cable
User Manual/Manual de Uso
stand
Audio cable
MK5 S
Publicidad
