Lorex HC64A Serie Guia De Inicio Rapido página 22

3. Align the arrows between the mounting
bracket and plate. Push the bracket in to install,
then slide down to lock in place.
You will hear a 'click' when the bracket is
installed.
4. Attach the camera to the mounting bracket
using the thread insert at the rear of the
camera. Rotate the camera clockwise until
attached, then tighten into place with the
adjustable nut.
5. Adjust the camera to the desired angle.
Note: If the camera is not holding in place or
difficult to adjust, slide the bracket up to detach
from the mounting plate. Tighten or loosen the
3 screws at the back of the mounting bracket to
adjust accordingly. Repeat steps 3-5 to re-install.
18
HC64A_QSG_TRILINGUAL_R4.indd 22 HC64A_QSG_TRILINGUAL_R4.indd 22
Adjustable screws
Back - Mounting bracket
19
2021-06-15 4:42:22 PM 2021-06-15 4:42:22 PM