User Guide - LG Health iSystem Manual Del Usuario

Operation guideline
Initial use
1. Place the device on any flat and stable surface.
2. Remove the water tank, add tap water into the wider compartment until the
maximum level mark is reached and return it to its original position.
3. Plug in the device.
4. The water purifier automatically flush the filter system and the internal pipes for
2 minutes. After flushing, the remaining water in the tank must be emptied and
replaced with fresh tap water.
5. The machine automatically starts water production. It can be used normally after
the water filtration is finished (water needs to be changed once in the whole water
filtration process to completely fill the internal purified water tank).
6. When the machine is in ''Lock'' mode, press the ''Hot'' key (100ºC Hot) and drain
all the water until the inner tank of pure water is empty (you will know it is empty
when the drop-shaped light comes on). Refill the tap water tank and repeat the
process 3 times.
Daily use
To obtain water. The device has six different water temperature levels. By pressing
the Honey, Milk and Normal (normal water temperature) buttons you can dispense
water directly. The other three buttons (Hot, Coffee and Tea) will only dispense
water once the Lock button has been pressed beforehand.
* If any temperature button is pressed during water dispensing, the outflow stops
and restarts when any water temperature button is pressed.
Attention
(1) This device is equipped with quantitative water output protection. When the
water flow exceeds 400 ml, it stops automatically.
(2) When drinking hot water, do not place your hand under the water outlet to avoid burns.
(3) To prevent the mechanisms from overheating during the first use, the device
shall only purify water at normal temperature. Only after this prevention period will
the machine dispense hot water.
(4) The device lock shall be automatically activated when no water flow or activity
is detected on the control panel after 10 seconds.
Max
Water changing
When the Add Water indicator lights up, the tap
water level must be replenished. Drain the residual
water and refill the tank with tap water up to the
maximum level mark.
Sleep
Once the device has filtered all the water, and if
no activity is detected within 1 hour, it will enter
the sleep state to save electricity. By pressing a
random temperature button, the device will leave
the sleep state and the standby mode will be
activated.
7