Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
5. USING THE LED LIGHT
To turn on the light simply press the on/off switch. When
you release the on/off switch, the light will be off.
LED lighting increases visibility in dark or enclosed areas.
6. USING BELT CLIP (SEE FIG. E1,E2)
Screw the belt clip on the tool with the screw provided in
the plastic bag. The belt clip can be clipped on your belt or
pocket, etc.
7. BATTERY CAPACITY INDICATOR
Your tool is equipped with battery capacity indicator. Press
the on/off switch halfway or fully, the battery capacity
indicator will light up to show the amount of charge left in
the battery.
Fuel Gauge
3 lights
2 lights
1 light
8. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the
load on the machine immediately and allow cooling for
approx. 30 seconds at the highest no-load speed.
9. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for the power tool cannot be
subject to overload. When the load is too high or the
allowable battery temperature of 75 °C is exceeded, the
electronic control switches off the power tool until the
temperature is in the optimum temperature range again.
10. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep discharging by
the "Discharging Protection System". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
18
Capacity
>70%
40%~70%
<40%
TROUBLESHOOTING
1. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems and having not used a battery
pack for a prolonged time will reduce the battery pack
working time. This can be corrected after several charge
and discharge operations by charging & working with your
driver. Heavy working conditions such as large screws
into hard wood will use up the battery pack energy faster
than lighter working conditions. Do not re-charge your
battery pack below 0
C and above 45
o
performance.
2. WHY DOES THE TOOL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position.
Push the trigger and the tool will start to rotate.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
For Battery tools
The ambient temperature range for the use and storage of
tool and battery is 0
C-45
o
The recommended ambient temperature range for the
charging system during charging is 0
C as this will affect
o
C.
o
C-40
C.
o
o
EN
Publicidad
