Publicidad
Idiomas disponibles
Idiomas disponibles
DMX 512 signal amplifier.
Do not use two outputs to separate the connection, if separate a continuous connection
to branch, DMX512 splitter is necessary.
Attention! vertically up to put the fixture, the sh ortest safe distance between the
fixtures must be ≥900 mm, the installation layout diagram as shown in the picture.
To prevent the reflection and interference of receiving the control signals, we must
install a terminal plug at the end of each branch of 3pin or 5pin output socket.
(welding a 0.25W 120
Ω
6.4 CABLE CONNECTION
Connect the DMX data : from the controller to the near est controller equipment 3pin or 5pin
socket , and then from th is equipment output connected to the next equipment input, like this
continuous connecting, finally the output of the terminal equipment for the data cable insert a
terminal plug .
If use DMX512 distributor, the controller co nnect to the DMX512 distributor' s input first ly,
then connect the next equipment from the output of the distributor, according to this method,
Final l y match the terminal plug .
7. AC power . .
7.1 VOLTAGE , FUSE SPECIFI C ATION
Input Voltage
200 -240V
100 -120V
MOVILED 105/4
resistor between the 2 and 3 pin of 3pin or 5 pin socket.
Fuse
5A 5×20 （Main fuse ）
10A 5×20 （Main fuse ）
User Manual/Manual de uso
Terminal plug
6
EN
Publicidad
