Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
CHARGING
A) BATTERY CHARGING
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another battery
charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the battery pack
may become too hot to permit charging. Allow time for the
battery to cool down before recharging.
When the battery is charged for the first time and
after prolonged storage, the battery will only accept
approximately 60% charge. However, after several charge
and discharge cycles the battery will accept a 100% charge.
B) TO REMOVE OR INSTALL BATTERY PACK
(See Fig. A1)
Depress the Battery Pack Release Button to release and
slide the Battery Pack out from your tool. After recharge,
Slide it back into your tool. A simple push and slight
pressure will be sufficient.
C) CHARGING PROCEDURE(See Fig. A2)
NOTE:
a) Do not use any charger other than that specifically
provided for use with the equipment.
b) If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c) The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged
before using the first time.
d) Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used
for long periods of time, charge the battery every 3-6
months.
1) Plug the charger into an appropriate outlet.
2) Place the battery pack into the charger
3) When charging is completed, unplug the charger and
remove the battery pack.
WARNING: When battery charge runs out after
continuous use or exposure to direct sunlight or
heat, allow time for the battery to cool down before
recharging to achieve the full charge.
EN
CHARGING INDICATOR
Light
ON/OFF
Red on
Green on
2. TO REMOVE OR INSTALL BATTERY PACK
(See Fig. B)
Depress the battery pack release button to release and
slide the battery pack out from your tool. After recharge,
slide it back into your tool. A simple push and slight
pressure will be sufficient.
OPERATION
1. INSERTING A BIT HOLDER, SOCKET OR
SCREWDRIVER BIT
Pull the collet locking sleeve forward. Fully insert the
desired bit into the chuck to the stop and release the
collet locking sleeve.
2. REMOVING A BIT HOLDER, SOCKET OR
SCREWDRIVER BIT (See Fig. C)
Pull the collet locking sleeve (7) forward. Take the tool out
of the chuck and release the collet locking sleeve.
NOTE: The chuck accepts only standard 1/4"
hexagonal shank accessories with power
groove.
3. SWITCH LOCK
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the direction
of rotation selector in the center position.
4. REVERSIBLE
For drilling and screw driving use forward rotation
marked"
" (lever is moved to the left). Only use
reverse rotation marked"
right) to remove screws or release a jammed drill bit.
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
5. LED LIGHT (6)
The sight light allows you to keep a clear view under less
illuminated circumstances. To turn on the light simply
press the on/off switch. When you release the on/off
switch, the light will be off.
LED is also a battery capacity indicator. It will flash when
power gets low.
Status
Charging
Fully Charged
" (lever is moved to the
17
Publicidad
