Tumama Kids TM24X Manual De Usuario página 17

WARNING
●From birth to 5 months.
●The toy is intended to be assembled by adult.
●To be used under the direct supervision of an adult.
●Possible entanglement or strangulation. Remove toy when baby begins to push up on hands and knees.
●Attach this toy out of the reach of the child. To prevent possible injury by entanglement, remove this toy when
the child starts trying to get up on its hands and knees in a crawling position.
●Remove the cord loop before giving the rattle toys to a child - finger injury hazard.
●This toy is not intended to be "mouthed" by the baby and should be positioned clearly out of reach of the
baby's face and mouth.
●On cribs with adjustable mattress levels, the highest position may allow the toy to be too close to the baby.
The second or lower position is more appropriate.
●The drop side of the crib should never be lowered with the toy in place and the baby left unattended.
●Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to a crib or playpen according to
the instructions. Check frequently.
●Do not add additional strings or straps to attach to a crib or playpen.
●Keep away from ignition sources.
---------------------------------------------------------------------
●Crib hanging toys are not meant for children to hold in their hands;
●If a hanging toy is attached to a crib or play fence, remove it when the baby begins to stand on his hands and
knees;
●If mounted on a wall or ceiling, the hanging toy should be installed so that it is clearly out of reach of a standing
infant;
●According to the requirements of the instructions, the provided fasteners (rope, strap, fixture, etc.) should be
firmly connected to the crib or game fence, and often checked;
●No other ropes or straps should be attached to a crib or play fence.
Installation instructions
●The crib hanging toy should not be held by the children.
●If the baby mobile is attached to the cribs, When the baby want to stand up, the crib mobile must be removed to
avoid danger.
●If the baby mobile is attached to other places, the hanging toys shall be installed correct ly so that the infants
can not touch it obviously.
●According to the instructions, please fix the crib mobile onto the cribs firmly, and checked frequently.
●No other ropes or straps should be attached to the cribs.
Battery installation method
1. Confirm that the toy's power is turned off.
2. Locate the battery cover on the bottom of the toy and loosen the screw with
a screwdriver.
3. According to the instructions in the battery box, install 4 AA / LR06 / AM3 1.5V
batteries into the musical toys.(Recommended to use a new alkaline battery to get
the best performance from the product)
4. Replace the battery cover and tighten the screws.
Battery Notices
1. The musical toys uses 4 AA / LR06 / AM3 1.5V non-rechargeable batteries.
2. The battery should be taken out and loaded in accordance with the polarity
and voltage signs on the toy battery box. The battery should not be short circuited.
3. Non-rechargeable batteries cannot be charged.
4. Different types of batteries or old and new batteries cannot be mixed to use.
5. Only the same or equivalent battery as the recommended battery can be used.
6. The used battery should be taken out of the toy. If it is not used for a long time, please take out the battery in
the toy.
7. The power terminals must not be short-circuited.
8. Cannot connect to more than the recommended number of power supplies.
Common Troubleshooting
If there is a sudden crash in the course of the game, please take the following steps to troubleshoot:
1. Turn off the device.
2. Take out the battery, shut down power supply.
3. Leave the device for a few minutes before reloading the battery.
4. Reset.
5. If you can't troubleshoot it, please try new batteries again.
Maintenance
1. Wipe the surface with a soft dry cloth to keep the toys clean.
2. Avoid direct sunlight and keep away from any heat sources.
3. Please take out the battery when you are not using it for a long time.
4. Do not collide with hard objects or attempt to disassemble the device.
5. Do not immerse the toy in water and avoid dampness.
Uses 4 AA / LR06 / AM3
1.5V batteries
(Not included in the package)
15