Draining The Unit; Cleaning Instructions For The Faucet; Machine Disposal - Fagor Slim Line Manual De Instrucciones

4.2.3 Draining the Unit

Each unit has a
condensation from the evaporator coil and evaporates it at an external
condensate evaporator pan. Each drain can become loose or disconnected
from moving or bumping the drain.
IF YOU NOTICE EXCESSIVE WATER ACCUMULATION ON THE INSIDE OF THE
UNIT be sure the drain tube is connected from the evaporator housing to
the condensate evaporator drain pan.
IF WATER IS COLLECTED UNDERNEATH THE UNIT you may want to check the
condensate evaporator drain tube to be sure it is still located inside the
drain pan. The leveling of the unit is important as the units are designed to
drain properly when on a level surface, if your floor is not level this can
also cause
obstructions; typically food product is found blocking drain lines causing
water to back up and overflow the drain pans.

4.2.4 Cleaning Instructions for the Faucet

Proper cleaning is important for the beer faucet, drain pan or any item
coming in contact with food or beverages to prevent odors and tastes from
bacteria. Prior to removing the faucet for cleaning, close the tap valve at
the keg.
The faucet should be cleaned every week. Using the spanner wrench
provided, remove the faucet from the shank and thoroughly clean with hot
water and detergent. Rinse completely and reinstall the faucet.(Note: The
faucet may be taken apart for more thorough cleaning.)
NOTICE
This cooler is designed to maintain your beer keg temperature with in the
most desirable range of 35° to 40°F. You can expect this temperature with
the proper temperature control setting and in a normal environment. It is
important to understand that when the keg of beer is purchased, it must be
installed inside the cooler as soon as possible to avoid excessive warm-up
of the beer. If this happens, it may take many hours for the temperature to
be reduced to the desirable range.
4.3

Machine disposal

The product's life-cycle is around 7 to 10 year from the first use and operation
date.
FAGOR equipment is manufactured without dangerous or toxic materials. Some
parts of the equipments are biodegradable.
The disposing after the product's life-cycle shall be determined by the customer
according to the rules and laws established in the city or State of residence.
REMEMBER TO TAKE CARE OF THE ENVIRONMENT.
Manual Instructions
drain located
drain problems. Be
8
fagorindustrial.com
inside the unit which
sure all drain lines
removes the
are free of