Publicidad
Idiomas disponibles
Idiomas disponibles
Turn the thrust roller unit
„
(see Fig. I).
Loosen the feed roll holder
„
it anti-clockwise and pull it forwards and
off (see Fig. J).
On the top of the feed roll
„
whether the appropriate wire thickness is
indicated. If necessary, the feed roll has to
be turned over or replaced. The supplied
welding wire (Ø 0.9 mm) must be used
in the feed roll
19
thickness of Ø 0.9 mm. The wire must be
positioned in the front groove!
Erect the feed roll holder
„
screw in a clockwise direction.
Remove the burner nozzle
„
it anti-clockwise (see Fig. K).
Unscrew the welding nozzle
„
(see Fig. K).
Guide the cable assembly
„
away from the welder as straight as
possible (place it on the floor).
Take the wire end out of the edge of the
„
spool (see Fig. L).
Trim the wire end with wire scissors or
„
a diagonal cutter in order to remove the
damaged, bent ends of the wire
(see Fig. L).
Note: The wire must be kept under
tension the entire time in order to avoid
a releasing and a roll out! Therefore it is
recommended to carry out the work with
an additional person.
Push the flux cored wire through the wire
„
31
feed guide
(see Fig. M).
Guide the wire along the feed roll
„
and push it into the cable assembly
32
holder
(see Fig. N).
Swivel the thrust roller unit
„
the feed roll
19
Mount the adjustment
„
O).
Set the counter pressure with the
„
adjustment screw. The welding wire must
be firmly positioned between the thrust
roller and feed roll
without being crushed (see Fig. O).
84
GB/MT
28
to the side
30
by turning
19
, check
with the specified wire
30
again and
9
by turning
15
12
28
towards
(see Fig. O).
27
screw (see Fig.
in the upper guide
19
Switch on the welder on the main
„
switch.
Press the torch button
„
Now the wire feed system pushes the
„
welding wire through the cable assembly
12
and the torch
As soon as 1 – 2 cm of the wire pro-
„
trudes from the torch neck
torch
Switch off the welder on the main switch.
„
Screw the welding nozzle
„
Make sure that the welding nozzle
matches the diameter of the welding
wire used (see Fig. Q). When using the
delivered welding wire (Ø 0.9 mm), the
welding nozzle
0.9 mm must be used.
Screw the burner nozzle
„
the torch neck
plug from the socket prior to each mainte-
nance task or preparatory work in order to
prevent the risk of an electric shock, injury or
damage.
z Using the device
z Switching the device on
and off
Switch the welder on and off on the main
„
5
switch. If you do not intend to use the
welder for an extended period, remove
the plug from the power socket. This is
the only way to completely de-energise
19
the device.
z Setting the welding current
and wire feed
The control dial
can be used to adjust the material thickness
to be welded. Power and wire feed are
controlled automatically.
Recommended welding wire diameter for the
material thickness given
11
.
10
.
11
button again (see Fig. P).
15
with the labelling
(see Fig. R).
33
Always unplug the mains
on the front of the welder
7
5
33
, release the
15
back on.
15
back onto
9
Publicidad
