Publicidad
Idiomas disponibles
Idiomas disponibles
BOILER ASSEMBLY
1.
Remove the Boiler from its packing and make sure all packaging has been
removed (including the protective bags). Put the station on a flat and solid
surface.
2.
Unscrew the Safety Cap (1). Fill the boiler with a maximum of 8 cups (1.9
litres) of water for the 4100IS. Use the funnel supplied, making sure you do
not overfill the tank (you can also use the water stick to determine the
water level in the steam tank).
Note:
To preserve the life of your boiler we recommend distilled water. Tap
water is okay, but more cleaning is required. See maintenance section for
more cleaning information.
How to use the water stick:
your finger on the end of the water stick. While holding the end, remove the
water stick from the boiler tank. The water level capacity will then appear
on the stick measurement to indicate the level.
IRON ASSEMBLY
1.
Remove iron from packaging and ensure all protective bags/outer
packaging has been taken off.
2.
It is recommended to put the iron on the iron pad (supplied), as the pad will
withstand the temperature of the iron.
3.
Insert the Steam Cord Holder (8) into the flange on top of the boiler and
attach the spring on the iron hose to the coil end of the wand.
Fully insert the water stick into the tank. Place
8
9
Publicidad
