Husqvarna HA200 Manual De Usuario página 9

3. Examine that the product is in perfect working order.
Examine that all nuts and screws are tight.
4. Make sure the gear housing is lubricated correctly.
To lubricate the bevel gear and gearbox on
See
page 11 for instructions.
5. Examine that the cutting attachment stops when the
throttle/power trigger is released.
6. Only use the product for the purpose it was intended
for.
7. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides.
2. Adjust the speed to align with the work load.
3. Make sure that the motor does not touch the hedge.
4. Hold the product near your body for a stable work
position.
5. Make sure that the end of the cutting equipment
does not touch the ground.
6. Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the cutting unit
The cutting unit can be adjusted in 10 different positions.
1183 - 002 - 16.01.2023
WARNING:
unit when you adjust the angle.
1. Let the engine/motor run at idle speed and make
sure the cutting unit does not move.
2. Pull down the position adjustment handle.
3. Tilt the cutting unit to the correct position. Use 1 of
the procedures that follow.
a) Use the handle.
b) Push the end of the cutting unit against a stable
surface.
4. Release the position adjustment handle to lock the
cutting unit.
5. Push the cutting unit against the hedge to make sure
that it is locked.
To adjust the friction for angle
adjustment
WARNING:
unit when you adjust the friction.
Do not operate the cutting
Do not operate the cutting
9