BaByliss PRO 4rtists SNAPFX FX797E Manual De Instrucciones página 9

ON/OFF SWITCH
To operate trimmer, simply slide
switch to ON (marked "I"). To stop
operation, set to the OFF (marked
"0") position.
VERY IMPORTANT: Blades must
be cleaned and oiled on a regu-
lar basis for proper functioning.
Failure to regularly clean and
oil the blades will void the
warranty.
TRIMMER MAINTENANCE IN-
STRUCTIONS
REPLACING (REMOVING) BLADE
SET
To remove the blade set, turn the
trimmer to the OFF '0" position.
Turn the trimmer upside down so
that the teeth of the trimmer are
facing down. Place the trimmer
on a flat surface and using the
screwdriver provided, loosen the
fastening screws from the blade
set. Remove the blade set from
the trimmer (see Fig. 1).
Fig. 1
Blade set
Blade screws
To install or replace your trimmer
blade set, reverse the procedure,
aligning the blade cushion shaft
into the moving blade cushion
(see Fig. 2). With the blade held in
place, replace blade screws and
tighten loosely. Turn the trimmer
over and align the blade set
parallel to the trimmer's upper
housing.
Fig. 2
Screws
Moving blade
Fixed blade
Screws
Screw holes
BLADE CARE
Because the trimmer blades are
precision-made for a very spe-
cial use, they should always be
handled with care and cleaned
regularly to ensure maximum per-
formance. Each time you finish us-
ing the trimmer, take the cleaning
brush provided and brush away
any loose hair that has collected in
the blades. Attach the blade guard
and then store the trimmer to pro-
tect the blades until the next use.
Any other servicing should be
performed by an authorized
service representative since the
appliance has no other user-ser-
viceable parts.
DO NOT RINSE BLADE, TRIMMER
OR CHARGING STAND
9
Blade cushion