Publicidad
Idiomas disponibles
Idiomas disponibles
∙ This appliance is designed for storing wine only.
∙ To prevent the risk of personal injury or damage to the
unit, it must only be transported while in its original
packaging. Two people are required for unpacking and
installation.
∙ Caution: Keep any packaging materials well away from
children – these are a potential source of danger, e.g. of
suffocation.
∙ The power cord should be regularly examined for any
signs of damage. In the event of such damage being
found, the appliance must no longer be used.
∙ To avoid the risk of fire, do not place any electric
appliances on top of the unit. Do not place any liquid
containers on top of the unit: this will prevent any
leaking or escaping liquid damaging the electrical
insulation.
∙ Do not lean or put undue weight on the shelves, door
etc.
∙ Protect the inside of the unit at all times from open
flames and any other sources of ignition.
∙ Remove the plug from the wall socket
- in case of any malfunction,
- before de-frosting,
- during cleaning,
- before maintenance or repair work is carried out.
∙ When removing the plug from the wall socket, never pull
on the power cord; always grip the plug itself.
∙ We reserve the right to introduce technical modifications.
Familiarisation
1.
Door hinge cover
2.
Door hinge
3.
Double-walled glass door
4.
Power cord
5.
Temperature control
6.
Chrome-plated storage racks
7.
Housing
8.
Drain channel
9.
Compressor
Before using for the first time
∙ Remove any exterior and interior packaging materials.
∙ Please ensure proper disposal of all packaging
materials.
∙ Clean the unit according to the instructions given in the
De-frosting and cleaning section.
∙ The unit should only be transported in its vertical
position; do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is first switched on, a slight 'new' smell
may be noticed. However, this will disappear once the
cooling process has begun.
Installation
∙ The appliance should be set up in a well-ventilated, dry
room.
∙ It should be operated in conditions where the relative
humidity is no more than 70 %.
∙ The product data sheet contains details of the ambient
temperature range suitable for this appliance.
∙ Do not place the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed
from the wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and
do not position it next to any heat sources (radiators,
cookers etc). If this cannot be avoided, however,
suitable insulation must be in installed between the heat
source and the unit.
∙ The unit must not be installed inside a cabinet, nor
directly below a hanging cupboard, shelf or similar
object.
∙ Ensure that the door can swing open to an angle of 90°.
∙ If the floor is uneven, the adjustable feet on the unit can
be used to compensate and ensure optimum stability.
Ventilation
The heated air around the unit must be able to circulate
freely. Therefore, ensure that the circulation around and
above the unit is not obstructed.
The clearance must be at least 150 mm.
11
Publicidad
