Stanley ST-42-BDF-E Manual De Usuario página 3

To Reduce The Risk Of Electric Shock, Do Not Expose To Water Or Rain or use in
WARNING
damp locations.
Do not operate any fan with a damaged cord or plug. Discard fan or return to an
WARNING
authorized service facility for examination and/or repair. Do not run cord under car-
peting. Do not cover cord with throw rugs , runner, or similar coverings. Do not route cord under fur-
niture or appliances. Arrange cord away from traffic areas and where it will not be tripped over.
Installation work and electrical wiring must be done by qualified person (s) in accor-
WARNING
dance with all applicable codes and regulations.
When servicing or replacing a component requires the removal or disconnection of
WARNING
a safety device, the safety device is to be reinstalled or remounted as previously
installed before operating this fan.
WARNING
Use this fan only in the manner intended by the manufacturer.
- Before operating always check fan for loose or damaged parts. Inspect power cord for any dam-
age. Never use fan if any parts are damaged or missing. Never use fan without safety guards
attached.
- Operate only on 220-240 volt, 50 Hz (cycle) current with a minimum of a 15 amp circuit.
- When used with an extension cord, use only cord of proper size (Amp rating), UL listed, and with
receptacle to accept three prong grounded plug furnished on the fan's power cord. Always keep
power cord and extension cords away from heat, oil, and sharp edges. Inspect cords periodically
and replace if damaged.
1. Slide wheel axle through wheel support frame.
2. Slide one (1) wheel onto either side of axle.
3. Secure wheel with one (1) cotter pin.
4. Place the fan on level ground in a safe, desired
position then connect to an approved power
source.
© 2021, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
NEVER LEAVE A FAN UNATTENDED WHILE
OPERATING OR WHILE CONNECTED TO A
Safety Information
Installation and Assembly
ST-42-BDF-E
3
POWER SOURCE