DINUY TI HEB K26 Instrucciones De Uso página 3

EN
INSTRUCTIONS MANUAL
Ref. TI HEB K26
HELIOS WIRE-FREE DOORCHIME KIT
Ref. TI HEB B01
HELIOS EXTRA DOORCHIME
RECEIVER
TRANSMITTER
FUNCTIONING
● Transmitter pushbutton
● Back of the doorchime:
Batteries
1 Turning ON/OFF
When turning-on the doorchime, the led keeps on lighting for 1
second approximately. When turning off the led flashes.
2
Volume
4 different levels can be adjusted.
When the doorchime is turned-off, the volume level is reset,
returning to its maximum level when turning-on it again.
Tune selector
3
Up to 32 different tunes can be selected.
Different examples of tune setting:
● The same doorchime with one or several pushbuttons (up to
30 maximum), and for every transmitter the same tune sounds.
Switch
position:
ON
1
● The same doorchime with several pushbuttons and each
transmitter plays a different tune:
Steps to be done with each transmitter.
Switch
position:
ON
1
● One or several pushbuttons (up to 30) and a different tune
sounds when any of the pushbuttons is pushed:
● Back of the doorchime:
4
Learning / Code erasing:
● Learning: the learning process between the pushbutton and
the doorchime is already adjusted from factory.
To install a new extra transmitter (EM HEB 001) or an extra
doorchime (TI HEB B01) along with the already installed, a new
codification process must be done following the instructions
attached to any of the New codification process if needed:
No caso de ser necessário realizar a aprendizagem do
conjunto, a forma de actuar é a seguinte:
1.- Place the batteries according to the indicated polarity (+/-).
2.- Turn-on the doorchime and, with the help of a thin point, do
a short pulsation (1sec) in the "learning/erasing" hole.
From that moment, and for 30sec, the led will keep
turned-on and the doorchime will be ready to receive the
transmitter's code during that time..
3.- Press the pushbutton until the doorchime sounds. This will
indicate that the learning process has been done correctly.
After it the doorchime will go automatically to its normal
mode.
4.- In case that more than 30seconds had gone by without
doing the process, repeat the procedure.
● Code erasing If is required to erase the learned codes, it is
necessary to press the "learning/erasing" hole with a thin point
for more than 4sec. When the code is erased, the led will flash
twice, showing that the process has been done correctly.
DINUY, S.A. Auzolan, 2, 20303, IRUN, SPAIN
● Portable. Can be traslated to any place of the house,
garage, garden, etc. within a range of 200mts.
● Switch ON-OFF.
● Volume control.
● Battery operated (3 x 1,5V.) batteries, type R-6
(not included).
● 32 different tunes can be selected through a swicht.
● Powered by a 3V. battery, type CR2032 (included).
● It can be installed outdoors or indoors, but never on
a metallic surface. It can be fixed to the doorframe or
wall with two screws.
Metallic obstacles, walls and so, can
reduce its range.
2
2
Switch position in each pushbutton:
Declaration of conformity CE
www.dinuy.com
O N
1
2
Battery
Press until
finding the
required
tune.
ON
1 2
4
4
guarantee
Switch
ON
1 2
LED
Turning
1
ON/OFF
2
Volume
Tune
3
selector
Select the tune with
the key (tune
selector).
Once the tune is
found, set the switch
in this position:
1
Learning /
Code erasing
ON
2