Gastrodomus WM35DD Manual Del Usuario página 23

Replacing the type of detergent and rinse aid: If the type of detergent/rinse aid is being changed, even if it is the same
brand, the intake and delivery pipes must be rinsed with clean water before connecting the new detergent/rinse aid
container. Otherwise, the mixture between different types of detergent/rinse aid could cause crystallisation, possibly
causing the dispensing pump to break. Failure to observe this precaution annuls the warranty and manufacturer liability.
34. CHANGING WASHING AND RINSE TEMPERATURES
The washing and rinse temperatures preset are:
washing temperature 60°C
rinse temperature 80°C
These working temperatures can be modified using the
appropriate trimmers called TNK and BLR in the electronic card:
Starting from the default marking, to decrease the temperature counterclockwise rotate the trimmer, according to the
other markings. Each marking corresponds to 5 ° C and the minimum value is 40 ° C for TNK and 60 ° C for BLR.
Starting from the default marking, to encrease the temperature clockwise rotate the trimmer, according to the other
markings. Each marking corresponds to 5 ° C and the maximum value is 75 ° C for TNK and 95 ° C for BLR.
35. THERMOSTOP FUNCTION
The thermostop function allows the machine to perform a rinse cycle respecting the pre-set temperature of the boiler, if
this temperature is lower at the end of the washing phase (resistance lamp on) the washing pump cycle is prolonged until
this default value is reached (resistance lamp off).
To exclude the thermostop function, press the Start button longer than 5 seconds until the light of the Start indicator lamp
will blink. To active again the thermostop function, press the Start button longer than 5 seconds until the light of the Start
indicator lamp will stays on.
36. MAINTENANCE
Once or twice a year, descale the boiler, the inner surfaces of the basin and the machine pipes.
•
• Each month, descale the rinsing and washing jets in a bath of vinegar or descaling agent.
• The tube inside the peristaltic rinse aid and detergent dispenser must be subjected to periodical maintenance (once
or twice a year).
Prolonged period of inactivity
If dishwashers remain unused for a long period of time, proceed as follows:
• Close the supply water cock.
• Completely empty the basin
Remove and clean the filter carefully
•
Completely empty the built-in dispenser tubes, removing the tubes from the cans
•
pag. 22 DOC. W010211 – REV.4