Publicidad
Step 12
To insert the drawers into your unit, line up the grooves on the DRAWER SIDES with the SLIDES on your unit. Slide the
å
drawer into the unit until it is about 3" or 4" away from the back of your unit.
Using your hammer, gently tap two DRAWER PINS (from Step 2) into the holes in your DRAWER SIDES (D486 and D488).
å
NOTE: The DRAWER PINS are used as a locking system for your drawer. When the DRAWER PINS are in place, you will
å
not be able to remove the drawer from your unit.
Repeat this step for the other drawers.
å
NOTE: Be sure you insert the smaller drawer (N) into the top space of your unit.
å
With a hammer, gently tap four SHELF SNAPS (8R) into the holes in the ADJUSTABLE SHELF (H).
å
Insert four METAL PINS (1R) into the hole locations of your choice in the LEFT END (B) and UPRIGHT (C). Set the
å
ADJUSTABLE SHELF (H) onto the METAL PINS so the SHELF SNAPS are resting on the METAL PINS. Push on the
ADJUSTABLE SHELF until each METAL PIN "snaps" into the SHELF SNAPS.
NOTE: If you wish to change the location of the ADJUSTABLE SHELF, tap
å
the SHELF up with the palm of your hand.
8R
Page 16
H
8R
(4 used)
1R
B
H
D486
C
416350
DRAWER PIN
N
J
J
D486
www.sauder.com/services
Publicidad
