Using The Device; Automatic Shut-Off - Hydas EMS to go Instrucciones De Servicio

• Examine the appliance frequently. If there is any damage visible or the sup-
ply cord is damaged, it must be replaced by the manufacturer or a qualified
person, to avoid a hazard
• The user must not attempt any repairs to the device or any of its accessories
• Manufacturers did not authorize to any maintenance agencies abroad.
• The manufacturer will not be held responsible for the results of maintenance
or repairs by unauthorized persons.

4 | Using the device

4.1 | Operating instructions
a Connect the two magnetic closures with the gelpads.
They can erase information imbedded on magnet strips of EC, credit cards,
bank cards, etc.
b Pull the protective film off of the gelpads. stick the gelpads next to each
other on the skin area to be massaged
c Connect the opposite end of the cable with the power source using the
micro-USB plug. Should the plug not fit, the Y-cord is provided as adaptor
for USB and USB-C.
d The blue LED is on. The device is now ready to be used.
4.2 | Start device
a Turn on the device (Button [+])
b Press [+] button to adjust the output intensity and the device will go into
the work status. There are 8 intensity levels. Press [-] button to decrease
the intensity down
c Keep press the [-] button to 2 seconds to turn off the device at any mode
in the boot state. The blue power LED remains lit until the device is un-
plugged from the power supply.

4.3 | Automatic shut-off

The appliance automatically switches itself off after 30 minutes.
4.4 | Uses
• There are 6 circulation modes: Massage, Hammer, Relaxation, Scraping,
Acupuncture, Cupping
• While the massager is running the 6 massage programs cycle automatically
• The duration of massage should not to exceed 30 minutes. Skin burns may
result from using for too long.
11