Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Adjustable Workshop Stool
IMPORTANT SAFETY INFORMATION
WARNING:
INJURY, USER MUST READ THIS INSTRUCTION
MANUAL BEFORE OPERATING PRODUCT.
a ) Read, study, understand and follow all
instructions before assembling or operating
this device.
b ) Do not stand on the stool.
c ) Weight capacity and other product capabilities
apply to properly and completely assembled
product only.
d ) The warnings, cautions, and instructions in this
manual cannot cover all possible conditions or
situations that could occur. Exercise common sense
and caution when using this stool. Always be aware
of the environment and ensure that the stool is used
in a safe and responsible manner.
e ) Do not modify this stool in any way.
Unauthorized modification may impair the function
and/or safety and could affect the life of the product.
There are specific applications for which the product
was designed.
f ) Use the right tool for the job. DO NOT attempt
to force small equipment to do the work of larger
industrial equipment. There are certain applications
for which this equipment was designed. It will be
safer and do a better job at the capacity for which
it was intended. DO NOT use this equipment for a
purpose for which it was not intended.
SAVE ALL WARNINGS
AND INSTRUCTIONS FOR
FUTURE REFERENCE
PRODUCT SPECIFICATIONS
Width
Depth
Overall Height
Adjustable Seat Height
Weight
Capacity
Seat Diameter
4
TO REDUCE THE RISK OF
18.11" (46.0 cm)
18.11" (46.0 cm)
43.4" (110.23 cm)
29.0"-33.7" (73.7-85.6 cm)
17.64 lbs (8.0 kg)
300.0 lbs (136.07 kg)
13.78" (35.0 cm)
READ ALL INSTRUCTIONS
ASSEMBLY
Before assembling stool, make sure all parts are
present. Compare parts with contents list. If any
part is missing or damaged, do not attempt to
assemble, install, or operate the product.
Contact customer service for replacement parts.
Leg Assembly (Fig. A, B)
1. Using the leg joining bracket
to line up with the bolt hole. Insert a leg bolt - M6 x 40
mm
7
(Fig A).
2. From the bottom, place the leg joining plate
up the bolt holes. Thread a locking nut - M6
the leg bolt (Fig A).
3. Install the remaining three legs but placing them in
between the leg joining bracket and the
plate. Line up the holes and insert a leg bolt M6 x 40
mm from the top of the leg joining bracket and thread
a locking nut - M6 onto each. Only hand tighten
the hardware at this time. Some play between the
components is desired.
Fig. A
8
9
6
insert a single leg
8
to line
13
leg joining
(Fig B)
7
6
13
9
onto
Publicidad
