Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure the bathtub in a horizontal line by adjusting the feet of bathtub.
4. STEPS BEFORE OPERATION
Water should be not less than 50mm above all water jets.
According to the sign of hot and cold water, adjust suitable water temperature.
Cold water first, then hot water.
(Temperature should be controlled and not exceed 40°C).
Test Air Switch for each use.
Plug into power outlet. Press test button first, reset button should pop up. For use, press reset button
again.
Do not operate product if this test was fail.
Use the computer panel to confirm that lights work.
Use switch of pump to check the Jacuzzi function and pump of speed to control the water pressure.
5. CLEAR AND MAINTENANCE
Use normal liquid detergent and soft cloth to clean the bathtub. Do not use detergent with acetone or
ammonia water to clean. If there is glue leftover from adhesive tape on the surface of bathtubs, soft
cloth dipped with petrol is the best thing to wipe away.
If there is scratch on the bathtub surface, you can use waterstone abrasive paper in 1500#-2000# to
polish, and then spread some toothpaste, polish again by soft cloth, and then it will be same as new one.
The scales in the surface of front glasses can't be cleaned up by some soft cloth to wipe after using such
faintly acid wash as lemon juice, vinegar etc.
There is no need to clean oftenly for the gold and chromium-plating parts.
Do not use rough tools and clean agent with chemical solvent or pellet to clean the surface of bathtub.
13
Publicidad
