Volpi KV81 Manual De Uso página 28

13 Operation start procedure
Please wear suitable cloth and glove when operate this tool. Always check tools before use,
make sure on/off switch and safe switch are all ok. The power should be put off when you
loosen the trigger. Stop using the tool in case of switch failure. Always check rated voltage
of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure blade stop fully before
touch it, otherwise blade will hurt your body.
•
Press the power switch.
•
Check the battery charge on the display. If the battery is low, proceed to recharge as specified in
Section 10.
•
After warning tone, please pull the trigger two times without holding. And the shear will be on
working condition after one more warning tone.
•
Do not overload cutting, it will protect pruning shear and battery not be damaged. Do not cut
branches exceeding the dimensions indicated into the technical datasheet.
•
Loose the trigger when the blade is jammed, the blade will resume maximum position.
Caution: Don't sway the pruner from the left to right in order not to damage the edge of blade
during the resume process of blade.
Check the working frequency of the blade in order to verify the good working condition.
When you stop working, please press the trigger and maintain 3 seconds unchanged then the blade will
keep closed state. Then press the power switch, check that the display is turned off and disconnect the
battery from the tool.
28