Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
This product requires assembly. To reduce the risk of injury to persons, never operate without
guards in place. The guard must always be on the tool to protect the user.
WARNING
• Always remove the battery pack from the
product when you are assembling parts, making
adjustments, cleaning, or when the product is
not in use.
1. Unfolding the Shaft
WARNING
• In order to avoid pinching your hands or fingers,
do not hold the shaft at the joints. Do not attempt
to start the trimmer until the shaft has been
locked.
a. Remove the battery pack from the trimmer.
b. Put your trimmer on the ground and carefully
unfold the shaft. Make sure that the cable
inside the shaft will not be pinched when
closing the hinge (D).
c. Use a Phillips screwdriver (not included) to
secure the shaft in locked position with two
screws (O).
2. Mounting the Guard
WARNING
• Always wear gloves when mounting or replacing
the guard. Be aware of the line-cutting blade on
the guard and protect your hands from being
injured by the blade.
a. Remove the battery pack from the trimmer.
b. Lift the trimmer head unit (F) and face it
upward; align the groove on the bottom of the
guard (L) with the raised portion on the base
of the trimmer head unit, and then slide guard
onto the base as shown (Fig. 2a).
c. Make sure that the two mounting holes in the
guard are aligned with the two assembly holes in the base of the shaft. Secure the guard
in place by tightening the two screws (N) with a Phillips screwdriver (not included). See
Fig. 2b.
1a
D
1b
O
2a
8
F
L
Publicidad
