Kärcher B 260 Manual De Instrucciones página 4

Safety instructions
ATTENTION
Risk of damage due to improper installation.
Improper installation or connecting up of the attachment can
damage the attachment as well as the vehicle or the machine.
Malfunctions and failures can occur on the attachment and the
vehicle or machine.
Have the assembly, installation and connecting up of the attach-
ment carried out only by a qualified specialist.
ATTENTION
Risk of damage due to electrostatic discharge (ESD)!
Electrostatic discharge (ESD) can damage electronic compo-
nents.
Take suitable measures to discharge the electrostatic charge be-
fore all work on the device electronics.
ATTENTION
Risk of damage due to sharp-edged objects and soiling!
Sharp-edged or dirty objects can cause damage such as scratch-
es, notches and deformation when coming into contact with de-
vice components. Dirty tools, cloths and work surfaces can cause
irreversible soiling and discolouration.
Use only suitable, undamaged and clean tools and auxiliary ma-
terials and exercise care when working. Place components and
devices only on clean, padded surfaces.
For safety and warranty reasons, we recommend that you have
Kärcher Service perform the assembly, installation and connec-
tion.
Keep these installation instructions for future reference or for fu-
ture owners.
Note
Also adhere to the operating instructions for the vehicle or device
in which the attachment is installed.
Order numbers and spare parts
You can find all order numbers and spare parts in DISIS.
Overview
The flashing beacon attachment kit consists of the following
parts:
Flashing beacon, orange (1 x)
1
Washer (2 x) and hexagonal head
2
Hexagon nut M6 (2 x)
3
Mizu connector
4
Cable tie with clip
5
Cable harness
6
M5x12 screw (2 x)
7
Flashing beacon holder
8
4
● Turn the programme selection switch to the "0" position.
● Pull out the KÄRCHER Intelligent Key (KIK) on the control
panel.
● Disconnect the battery plug.
Install the flashing beacon on the flashing beacon
M 6 hexagon nut
1
Washer
2
Flashing beacon
3
Flashing beacon holder
4
1. Push the cable set of the flashing beacon through the pipe
section from above.
2. Position the flashing beacon on top of the flashing beacon
holder and affix it with the washer and the hexagon nut M 6
(2x).
(Tightening torque: 6Nm)
Install the flashing beacon
Flashing beacon holder
1
Screws M5x12
2
1. Affix the holder of the flashing beacon using the
M 5 x 12 screw (2 x).
2. Unhook the cable harness of the flashing beacon so far that it
can be connected with the Mizu connectors with the adapter
of the device cable harness without slack.
English
Preparatory work
Installation
holder