Napier Sportz 57 Serie Instrucciones página 4

ATTACHING THE RAINFLY
Locate the back of the rainfly that goes
10
towards the cab of the truck (there will
be a zippered access panel at this end)
and drape over the tent.
SETTING UP THE AWNING
NOTE: Roll up the awning and secure with the
toggles when not in use.
Unfold each section of the NAVY BLUE fibreglass
12
awning poles. Insert the poles into the ceiling of the
awning, forming an X. Place the poles into the
pockets at the corners of the awning.
A. Unfold the top steel awning pole.
13
B. Ensure the clasp is OPEN before connecting
the poles.
C. Insert the top steel pole into the bottom pole
(bottom pole has the plastic clasp).
D. Adjust the height of the pole and close the clasp.
Place the pin located at the bottom of the awning
14
pole into the grommet hole at the tailgate of the
tent. Place the top end of the pole into the grommet
hole at the top corner of the awning.
Locate the straps on the corners of the awning and
15
secure to the clip at the tailgate of the tent (beside
the pole grommet hole).
OPTIONAL:
Secure the awning to the ground using 1 – 2 guy lines. Place the
16
ring end of the guy line over the pole pin located at the top of the
awning. Place the awning cap over the pin.
Stake the bottom loop on the plastic slider of guy line (figure A)
17
with a peg. Adjust the lenth of the rope by pushing the plastic slider
upwards until the line is tight (figure B).
Secure the rainfly
11
strap clips to the tent
(2 per side and 2 at
the tailgate) and
tighten if necessary.
16
17A
17 B