Ver 4.0_ES_EN_FR_IT_PT_02/22
The water heater is ready to use at the moment it is plugged to electrical network. The thermostat allows
the user to regulate the temperature from 7 to 75ºC using a high precision bulb. Using this regulation knob the
user could adapt the water storage temperature to the weather conditions and his particular needs.
The indications at regulation knob corresponds to the below approximate water temperatures inside the
tank:
Position '●': 7ºC. To avoid water freezing.
Position 'ECO': 55ºC approximately. Optimal temperature to reduce heat loses to environment and
reduce scales inside the appliance in hard water areas.
Position '+': 75ºC. Maximum water temperature inside the tank.
The operation of electric immersion heater is shown by pilot light.
2.- CLEANING.
The external parts of the water heater may be cleaned with a mild detergent solution. Do not use solvents and
abrasives.
Never try to repair any possible faults of the water heater by yourself, but inform about it the
3.- LEGIONELLA THERMAL DISINFECTION CYCLE
In order to reduce the proliferation of Legionella inside the electric water heater, disinfection cycles should be carried out
with the recommended frequency in the following cases:
1) If the device is disconnected for more than a month, a disinfection cycle must be carried out when it is switched on.
2) If the water temperature is kept constantly below 55°C on a regular basis, a disinfection cycle should be carried out at
least every three months.
To carry out the aforementioned cycle, the temperature regulation knob must be placed in its maximum position (> 70ºC).
Once the aforementioned temperature has been reached, leave the adjustment knob in this position for 10 '. After this time,
the water heater can be adjusted to the desired temperature as usual.
WARNING!: When the thermal disinfection treatment has just been carried out, the temperature of the water in the water
heater can instantly cause severe burns. Children, disabled and the elderly are the people at highest risk for burns. Check the
water temperature before taking a bath or shower.
4.- WATER HEATER DRAIN IN CASE OF FROST
At any risk for freezing of water in the water heater, the water must be emptied from it. In order to do it,
please follow the below instructions:
o
Unplug the appliance from electrical network.
o
Close the water inlet to the water heater.
o
Drain the water heater using the safety valve.
o
Protect the safety valve from freezing.
o
Fill the water heater before plug in it again to electrical network.
nearest authorised service workshop.
12