MSW Motor Technics MSW-HT2 Manual De Instrucciones página 14

1. Gently press in the push rod (2) and pull up and away. Remove the whole push
rod (2) from the staple magazine (3) (Fig. A).
2. Insert the staples into the staple magazine (3) from the open head (5) end (Fig.
B).
3. Insert the push rod (2) into the staple magazine (3) (Fig. C and D).
STAPLING
Strike a blow to the workpiece surface to be stapled with the face (4) of the head
(5) as if using a regular hammer. A staple is driven into the material at the point of
impact.
REMOVING STAPLES WITH THE STAPLE PULLER
The special profile of the product provides leverage. A small up and down motion is
enough to remove the staple from the material.
Removing staples from materials:
1. Slide the bottom half of the jaw (8) under the staple to have its bar between
the jaw halves.