SYSTEM INFORMATION
When the fi rmware upgrade is done, check the fi rmware details by following the steps below.
1.
With the unit in Stop mode, press the MENU button.
Press the ▲▼ buttons to select Setup, then press the
2.
ENTER or ► button.
Press the ▲▼ buttons to select System Upgrade, then
3.
press the ENTER or ► button.
Press the ▲▼ buttons to select System Information,
4.
then press the ENTER or ► button.
You can see detailed information about the current
fi rmware.
5.
Press the ENTER button to select OK.
System Upgrade menu will be displayed.
NETWORK SETUP
In some rare cases, the fi rmware upgrade may not succeed.
If this occurs, you may need to set up your IP address, Subnet, Mask,
Gateway and DNS by following the steps below.
To setup, follow steps 1 and 3 above
Press the ▲▼ buttons to select Network setup, then
4.
press the ENTER or ► button.
You will see a menu that allows you to make network
settings.
Press the ▲▼ buttons to select DHCP, then press the
5.
ENTER button.
M
If DHCP is set to On, you can't select IP Address, Subnet Mask or Gateway.
If DNS is set to Automatic, you can't select Primary/ Secondary DNS.
HDMI Setup
Photo
Parental Setup
Setup
System Upgrade
No Disc
No Disc
HDMI Setup
Parental Setup
Photo
System Upgrade
System Information
Setup
No Disc
No Disc
Network Setup
Upgrade Start
HDMI Setup
Parental Setup
Photo
System Upgrade
System Information
Setup
No Disc
No Disc
System Information
Network Setup
S/W : XXXXXX_XXX
Upgrade Start
Region : A/01 (BD/DVD)
OK
HDMI Setup
Photo
Parental Setup
System Information
Setup
System Upgrade
Network Setup
No Disc
No Disc
Upgrade Start
HDMI Setup
Parental Setup
System Information
Photo
Network Setup
System Upgrade
Network Setup
Setup
DHCP
: On
No Disc
No Disc
IP Address
: 000 . 000 . 000 . 000
Upgrade Start
Subnet Mask
: 255 . 255 . 255 . 000
Gateway
: 000 . 000 . 000 . 000
DNS
: Automatic
Primary DNS
: 000 . 000 . 000 . 000
Secondary DNS
: 000 . 000 . 000 . 000
Save
Cancel
s SELECT
² RETURN
English _47