Publicidad
Idiomas disponibles
Idiomas disponibles
USING TEMPERATURE PROBES
Use the provided meat probe to control your grill by following the steps below:
1.
Plug the meat probe into the port at the bottom of the controller*. Make sure to wear heat protective gloves.
2.
Insert the temperature probe into the thickest part of your choice of meat.
3.
Place your food on the cooking grate and close the grill lid.
4.
Once the index is displayed (P1, P2, etc.), press and hold for three seconds to set the target temperature. Use the
control dial to change the temperature value and press it to confirm the value.
*AUTO-WARM FEATURE: With the meat probe connected to port P1, set the target temperature desired for the food to
activate the auto-warm feature. This feature will automatically reduce the set grill temperature to 250 °F (121 °C) and
display the WARM icon after the probe temperature hits its targeted temperature. The grill will maintain at WARM
setting (for a maximum of 10 minutes) as it awaits the next user input. This is to help prevent food from overcooking if
the user is not present when the set meat probe temperature has been reached. To avoid this auto warm feature,
please use ports P2 to P4 instead.
USING TIMER
Press to set a timer in minutes and hours. The controller will alarm once the time has expired.
To set a timer:
1.
Press the button. The lower number display will flash. Adjust the minute value using the control dial. Push the
control dial to confirm.
2.
Now, the upper number display will flash. Adjust the hour using the control dial. Push the control dial to confirm
and start the timer.
The "HR" and "MIN" symbols will flash, indicating that the timer is running. Press the timer button once to check
remaining time. Press and hold the button for 3 seconds to cancel the timer.
USING SELF-CLEANING FUNCTION
To start the self-cleaning cycle, press MODE, then press the SELF CLEAN button.
•
The ignition icon, ZONE A icon and ZONE B icon will flash. After the ignition is successful, the ignition icon will turn
off and the ZONE A and ZONE B icons will stay on.
The grill temperature will be set to 600 ˚F and the grill will run for 10 minutes to burn off food residue. The grill will shut
down automatically after 10 minutes. To cancel the self-clean cycle, press and hold the SELF CLEAN button for
3 seconds or press the POWER button.
Grilling with the lid open
When grilling with the lid open, the grill thermocouple will not reach
the target temperature and will produce an error code. To avoid this,
override the target temperature by following the instructions below:
1.
With the burner(s) lit, press ZONE A or B.
2.
Press MODE to cycle through the heat settings (Low and
Medium). A horizontal line representing each setting will be
displayed.
3.
Press the dial to confirm the setting.
To return to automatic temperature control, rotate the dial to the
desired temperature and press the dial to confirm.
CAUTIONS
•
Place dust cap on cylinder valve outlet when the cylinder is not in use. Only install the type of dust
cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs
may result in leakage of propane. The gas must be turned off at the supply cylinder when the unit is
not in use. If the appliance is stored indoors the cylinder must be disconnected and removed from
the appliance. Cylinders must be stored outdoors in a well-ventilated area out of the reach of
children
•
Keep a spray bottle of soapy water near the gas supply valve and check the connections before
each use.
•
Each burner is adjusted prior to shipment; however, variations in the local gas supply may
make minor adjustments necessary.
34
Low
Medium
Publicidad
