Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATIONS
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage and personal injuries.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
•
After repair or before starting the engine, turn a minimum of 2 turns by hand and check the
timing again.
•
Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
•
Do not use locking tools for camshaft and crankshaft as a counter-holder, during loosening or
tightening screws on pulley, camshaft or crankshaft. This can damage tools and engine
components. Only use tools that are suitable for this purpose.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information.
USE
Piston
Height Adaptor (1),
to be used as
OEM 1 860 992000
1. Remove the spark plugs and screw the piston height adaptors into the spark-plug ports of cylinders
one and two.
2. Slowly turn the crankshaft until the notches (1) on the centre rod aligns on each adaptor stem.
3. Important: The dowel pin on the crankshaft must remain opposite the crankshaft position sensor.
4. If necessary re-fit the crankshaft pulley.
5. Remove the two blanking plugs from the camshaft casing.
6. Press the centre pin of the camshaft tool into the alignment slot of the camshaft (2).
7. Secure in place with the threaded hand wheel.
8. It may be necessary to remove the tools and turn the crankshaft one revolution until the tools
correctly engage.
9. After fitting the new timing belt, the tensioner pulley must be turned to the maximum position by
using the wrench (3).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Camshaft
Adjusting Tools (2),
to be used as
OEM 1 860 985000
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Tensioner
Adjusting Wrench (3),
to be used as
OEM 1 860 987000
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
